History of Tubal Sterilization

The first tubal sterilization procedure, reported in 1881, was tubal ligation and resection. Ligation and resection - or ‘tying tubes’ was the most common surgery for sterilization until the advent of laparoscopic surgery in the mid 1900’s. As laparoscopic surgery became more popular, electrocoagulation (electrical burning) of the fallopian tubes became an additional method of surgical sterilization. Tubal sterilization by electrocoagulation uses electric current to cut and destroy the portion of the tube that is exposed to the electric current. These portions of the tube eventually heal and close.

Monopolar Tubal Coagulation

The initial method of laparoscopic tubal coagulation, in 1962, used a type of electrical current termed monopolar current. Monopolar tubal electrocoagulation was a popular type of laparoscopic sterilization through the 1970’s and 1980’s. The medical community began to realize that the complication rate from this form of electric surgery was higher than for other electric surgical methods of tubal sterilization. Sterilization procedures done by monopolar current have gradually been replaced with bipolar current.

Bipolar Electrocoagulation of the Fallopian Tubes

The first reported sterilization using bipolar electrocoagulation was in 1972. This was done via a laparoscope inserted just under the belly button. During bipolar coagulation, the electrical current can be more precisely controlled, resulting in less tubal damage than monopolar coagulation. This sterilization procedure results in higher reversal success rates than monopolar electrocoagulation.

Reversing Tubal Sterilization

Many people, including doctors, mistakenly believe that tubal sterilization is permanent and irreversible. Although bipolar coagulation sterilization is intended to be permanent, this procedure can be reversed successfully in almost all cases. The success rates depend on how many different areas of the tube were damaged with electrocautery. Approximately 60- 70% of patients at Chapel Hill Tubal Reversal Center become pregnant after a reversal of a bipolar coagulation sterilization procedure. Chapel Hill Tubal Reversal Center is the only medical facility that specializes exclusively in reversal of tubal ligation. We perform tubal ligation reversals every day, and our tubal reversal doctors are experts in reversing all types of tubal ligations- or ‘untying’ tubes that have been ‘tied’!

Submitted by Dr. Charles Monteith

Hulka Clip Sterilization

One common form of female sterilization is the use of Hulka clips to block the fallopian tubes. The Hulka clip was approved for use in the United States in the 1970’s and was invented in Chapel Hill, North Carolina by Dr. Jaroslav Hulka at the University of North Carolina at Chapel Hill.

The Hulka clip is a small, gold plated stainless steel spring loaded clip. The clip in introduced into the abdominal cavity via a laparoscopic clip applicator. This image shows the open clip in the applicator and the tip of the laparoscope with its fiber optic lighted end. When the clip is placed across the fallopian tube, it is closed and a small spring holds the clip firmly across the tube. The Hulka clip has the advantage of damaging only a very small portion of the fallopian tube- approximately 7mm (the thickness of three quarters stacked on each other).

The Hulka clip causes bilateral tubal occlusion by squeezing a very small portion of the tube. The squeezed portion is deprived of its blood supply and eventually undergoes avascular necrosis (dies and is absorbed by the body). This causes the fallopian tube to be divided in half and the two ends to close up. The Hulka clip is held in place between the two divided tubal segments by a small amount of scar tissue which forms within the clip.

Hulka Clip Reversal

A common misconception is that the Hulka clips can simply be opened to reverse the sterilization process - that the tubes can be unclipped. Unfortunately, tubal ligation reversal for Hulka clips is not as simple as opening the clips. Hulka clip tubal occlusion is reversed by removing the section of the tube with the clip across it and then, using microsurgical techniques, joining the remaining tube segments back together in perfect alignment.

Tubal reversal of Hulka clip tubal occlusion is better than for most other methods of sterilization because such a minimal amount of tube is destroyed in the occlusion process. Approximately 76% of patients at Chapel Hill Tubal Reversal Center become pregnant after a reversal of a Hulka clip sterilization procedure.

Common Misconception About Tied Tubes

Many patients seem to imagine the fallopian tube is like a shoe lace which is tied up like a bow to prevent pregnancy. As tubal ligation reversal specialists, we wish it were that easy- then untying tied tubes would be easier!

‘Tying ones fallopian tubes’ is a common language phrase used to describe several different surgical procedures which result in sterilization (a procedure intended to permanently prevent pregnancy). The more correct medical term is bilateral (both sides) tubal occlusion (closure of the fallopian tube).

There are many different ways to occlude (close) the fallopian tubes: ligation and resection (tying and cutting), clips and rings, and coagulation (burning). No matter how the procedure is done the end result causes the tube to close, heal shut, and prevent sperm from fertilizing an egg.

Tubal Sterilization is Reversible

Many people believe tubal sterilization is permanent and irreversible. Although Hulka clip sterilization is intended to be permanent, this procedure is ideal for tubal reversal. The Chapel Hill Tubal Reversal Center is the one medical facility which specializes in tubal ligation reversal.

We have become experts in reversing all types of tubal ligations- or ‘untying’ tubes that have been ‘tied’!

Submitted by Dr. Charles Monteith

Tying Tubes is Not Like Tying a Shoe Lace

Many patients seem to imagine the fallopian tube is like a shoe lace which is tied up like a bow to prevent pregnancy. As tubal ligation reversal specialists, we wish it were that easy- then untying tied tubes would be easier!

‘Tying fallopian tubes’ is a common language phrase used to describe several different surgical procedures that result in tubal sterilization (a procedure intended to permanently prevent pregnancy). The more correct medical term is bilateral (both sides) tubal occlusion (closure of the fallopian tube).

Tubal Ligation Methods

There are many different ways to occlude (close) the fallopian tubes: ligation and resection (tying and cutting), clips and rings, and coagulation (burning). No matter how the procedure is done the end result causes the tube to close, heal shut, and prevent sperm from fertilizing an egg.

Filshie Clip Tubal Ligation

One common form of laparoscopic (camera) sterilization is the use of Filshie clips to occlude both fallopian tubes. The Filshie clip was approved for use in the United States in the mid 1990’s. The Filshie clip is a small titanium clip which is lined with a thin silicone cushion. The clip was an improvement over the Yoon Falope Ring and the Hulka Clip because it was as easy to apply with less risk of operative complications. The clip also has the advantage of destroying only a very small portion of the fallopian tube- approximately 4mm (approximately the thickness of two quarters stacked on each other). The adjacent tube is not affected. The majority of Filshie clips placed in the United States are done by laparoscopic surgery; however, there is a growing trend to use them for tubal occlusion at the time of cesarean delivery (c-section).

The Filshie clip causes bilateral tubal occlusion by squeezing a very small portion of the tube. The squeezed portion is deprived of its blood supply and eventually undergoes avascular necrosis (dies and is absorbed by the body). This causes the fallopian tube to be divided in half and the two ends to close up. The Filshie clip is held in place (in between the two divided ends) by a small amount of scar tissue which forms over the clip.

A common misconception is that the Filshie clips can simply be removed to reverse the sterilization process- that the tubes can be unclipped. Unfortunately, tubal ligation reversal for Filshie clips is not as simple as just opening the clips. Filshie clip tubal occlusion is reversed by removing the clips and using microsurgical techniques to open the closed ends and join the tubal segments back together in perfect alignment.

The reversal of Filshie clip tubal occlusion is usually technically easier than some other methods of sterilization because such a minimal amount of tube is destroyed in the occlusion process.

Approximately 76% of patients at Chapel Hill Tubal Reversal Center become pregnant after a reversal of a Filshie clip sterilization procedure.

Tubal Sterilization Can Be Reversed

Many people believe tubal sterilization is permanent and irreversible. Although Filshie clip sterilization is intended to be permanent, this procedure can be reversed. Chapel Hill Tubal Reversal Center is the one medical facility that specializes in tubal ligation reversal.

We have become experts in reversing all types of tubal ligations- or ‘untying’ tubes that have been ‘tied’!

Submitted by Dr. Charles Monteith